Baumatic P75SS Manuale Utente Scaricare il pdf (Pagina 23)

If it becomes necessary to replace a gas tap, then you should proceed

as follows:

o Remove the control knobs, pan supports, burners, hob fixing

screws and clamps.

o Remove the hob from the worktop and remove any underside

protective covers.

o Disconnect the fixings holding the tap to the fascia panel and

separate the assembly.

o Disconnect the gas pipe from the gas tap, then disassemble

them from the gas rail by removing the fixing screws.

o When fitting a new tap, ensure that a new gasket is used.

o Reconnect the gas tap, perform a gas soundness test and

then reassemble the hob.

Electrical connection

This appliance must be installed by a qualified

person in accordance with the latest edition of the

I.E.E. Regulations and in compliance with Baumatic’s

instructions.

Before connecting the appliance, make sure that the supply voltage

marked on the rating plate corresponds with your mains supply

voltage.

o Cable type: H05 RRF 3 core x 0.75 mm³

o The mains supply cable is supplied with this product.

Replacing the mains supply cable

If the mains supply cable is damaged, then it must be replaced by an

appropriate replacement which can be obtained from the Baumatic

Spares Department.

The mains supply cable should be replaced in accordance with the

following instructions:

o Switch the appliance off at the control switch.

o Open the box of the supply board.

o Unscrew the clamp (A) fixing the cable.

1 2 ... 18 19 20 21 22 23 24 25 26 27

Nessun commento

Baumatic P75SS Manuale Utente Pagina 23